Diy Faux Wood Beam Mantel

January 30, 2022 Post a Comment

If you don’t have a solid header then make sure you are securing them into the wall studs. A mantel is a decorative shelf above a fireplace, this is typically a built in piece and is the focal point of a living room or family room.

Build a DIY Faux Beam Fireplace Mantel Cover in 2020 (With

If you liked this post, you might also want to.

Diy faux wood beam mantel. They were screwed into a header behind the wall. Diy faux barn beam mantel. In our home, we have a real wood burning fireplace.

Faux farmhouse wood beam mantel. With the opportunity to remodel my master bedroom, it seemed the perfect time to try out my diy faux wood beam idea. I also wanted a mantel that i.

There is no exact rule on how long or wide the mantle should be. Make your fireplace a statement piece again Cut face board length of mantel plus an additional 1.5”.

After deciding i loved it, and wanted something more substantial, we decided to build a diy faux beam fireplace mantel cover.which was really easy, and really inexpensive. Just thought you'd want to know.😊) the long skinny pieces gave support to nail it together along with the center and end pieces. Depending on the material the existing beam is made of will affect some of the qualities of the faux wood beam.

To secure the diy wood beam mantel to the wall, we needed to screw in a few wood cleats. See more ideas about faux wood beams, wood beams, faux wood. We went with 72 inches since we wanted it to be slightly longer than the tv and fireplace insert, but smaller than the faux shiplap fireplace.

However, it sits in a corner and doesn’t have a mantel. Basically, we glued and nailed the pieces together with our handy dandy hitachi nail gun. This will be the bottom of the faux wood beam mantel.

While the faux wood beam will be water and insect resistant, it is not to say that the. Especially when i’m trying to make new wood look old. How to make faux wood beams materials:

I wanted them to float from one side of the wall to the other. Decide the length of the wood beam mantel. Wood beam mantel diy steps.

Repeating this with the board on the right, it will be lifted up toward the left to form a 90° angle where each of the mitered edges meet. I really wanted something that would fit this space behind our dining room table. You now have a fantastic looking beam mantel!

I started first by adding a single stained board to see how it looked. A few months ago, i wanted to change the look of our faux fireplace. The board above is my top board of my faux wood beam mantel.

The mantel is removed, the cleat is attached and now we’re ready to actually build the faux wood beam mantel. It’s based on personal preference. This allows seams to be hidden from the front.

Check out the final result! Cut side pieces to fit mantel width plus.75″ height so that only one seam can be seen from side. Diy rough hewn wood fireplace mantel by addicted 2 decorating;

I wanted the faux beams to be suspended, and not run along the ceiling since it was going to be impossible to do that because of the way the ceiling lines were. We slid the mantel onto the cleats and drilled in a few screws through the top of the mantel, into the cleats. Cut the top board the length of the mantel.

Using 3/4″ plywood, cut your top and bottom boards to the length and width of your cleat you built and attached above…. This will be the top of the faux wood beam mantel. Build a rustic faux beam mantel ;

I then cut shorter pieces of 2×4’s to support the box coming outward from the wall. (since this project, i purchased the ryobi cordless nail gun and i love it! We wanted our main center beam to be a little thicker than the side beams so we used 1″x8″x8′ boards for the very.

Our diy faux wood beams have made an enormous impact on the overall look of our home and i couldn’t love them more! Here are two posts i found helpful in informing my project: Should run you about $18 a piece.

To hang the mantel on the wall i cut a piece of 2×4 to fit inside the box across the width of the wall. Uncategorized / wednesday, february 28th, 2018.

How to Build a Faux Wood Beam Mantel Repurpose Life in